紫外透射仪快速指南

紫外线透射仪快速指南

紫外线透射仪说明

1.紫外线透射仪是一种用于凝胶成像的紫外线灯箱。

警告：

紫外透射仪能发出强烈的紫外线，紫外线辐射可能对未受保护的眼睛和皮肤造成危险，因此必须采取适当的预防措施。必须佩戴紫外线防护眼镜或紫外线防护面罩。有关紫外线防护眼镜和紫外线防护面罩的产品信息请联系XEPU的销售办公室。

紫外线透射仪操作说明

1.注意开关布置如上图所示。确保接通/断开开关处于断开位置。

2.将紫外线透射仪电源输入插入装置并供电。在检查是否遵守了安全预防措施之前，不要打开装置。

3.现在打开装置，确保开关灯亮起，装置中的灯均匀点亮。

4.不使用时请关闭设备。

5.如果装置无法点亮，请检查电源显示器是否存在，开/关开关是否处于接通位置。如果没有发现故障，请联系xepu的服务部门寻求帮助。

紫外透射仪产品介绍请浏览：紫外透射仪

UV Transilluminator Quick Guide

UV Transilluminator Description

1. UV Transilluminator is an ultra violet light box for use in gel imaging.

WARNING: UV radiation can be dangerous for unprotected eyes and skin, therefore,appropriate precautions must be taken. UV protective goggles or a face shield must be worn. Please contact XEPU's sales office for further details and accessories.

UV Transilluminator Operating instructions

1. Note the switch arrangement is as shown in the diagram below. Make sure that the On/Off switch is in the Off position.

2. Plug the mains input to the unit and supply. DO NOT switch the unit on before checking that safety precautions have been observed.

3. Now switch the unit on and ensure the switch lamp illuminates and the lamps in the unit illuminate evenly.

4. Please switch off the unit when not in use.

5. If unit fails to light up, check that the mains display is present, that the On/Off switch is in the On position. If no fault can be found please contact our service department for assistance.

Product Introduction：UV Transilluminators